Step 1: First, remove the front panel of the chassis for installation drive bezel and optical drive reverse then put into the chassis from the front panel of the chassis slot of 5.25 inches. Confirm the alignment of the front panel of the chassis of the CD-ROM drive flat initial fixed with two screws on each side of the optical drive, do not tighten, so you can fine-tune the location of the CD-ROM drive, and then tighten the screws, which is mainly on account of the aesthetics of the front panel of the chassis.
Step 2: Next to begin the installation data cables, similar to CD-ROM installation steps and hard, but the data cables only can use ordinary 40-pin IDE data cable, it is recommended that the 15Ft Black Premium S-Video Cable M/M SVIDHQ25 into the motherboard IDE slot , so that you do not set the optical drive and hard disk from the disk jumper. Specific installation process is not described in detail.
Tip: 40-pin or 80-pin IDE ribbon cable has three plugs, one connected to the motherboard IDE slot, the other two are connected to the main device from the IDE. If only one hard drive and a CD-ROM drive, then it is recommended that they are respectively connected to two IDE slots on the motherboard, so you can improve the efficiency of the system, and can solve some seemingly inexplicable.
The third step: the CD-ROM drive is generally also comes with audio cable, one end of the audio cable in the correct direction to insert the CD-ROM drive on the rear panel audio line interface, marked CD-In socket on the other end into the sound card. Some external sound card or onboard sound card also corresponds to a different brand of CD-ROM drive, to provide two or more CD-In socket, when we have to drive brand corresponding socket insert applicable.
Tips: tips to prevent audio cable plugged into the wrong
Because the audio line is the most easy to insert the wrong, in order to avoid such a situation occurs. We can carefully observe the root audio cable, audio cable connectors will have an arrow mark (generally white cord to the position) will be marked with the CD-ROM drive and sound card audio line interface "L" phase The corresponding insertion can.
Step 2: Next to begin the installation data cables, similar to CD-ROM installation steps and hard, but the data cables only can use ordinary 40-pin IDE data cable, it is recommended that the 15Ft Black Premium S-Video Cable M/M SVIDHQ25 into the motherboard IDE slot , so that you do not set the optical drive and hard disk from the disk jumper. Specific installation process is not described in detail.
Tip: 40-pin or 80-pin IDE ribbon cable has three plugs, one connected to the motherboard IDE slot, the other two are connected to the main device from the IDE. If only one hard drive and a CD-ROM drive, then it is recommended that they are respectively connected to two IDE slots on the motherboard, so you can improve the efficiency of the system, and can solve some seemingly inexplicable.
The third step: the CD-ROM drive is generally also comes with audio cable, one end of the audio cable in the correct direction to insert the CD-ROM drive on the rear panel audio line interface, marked CD-In socket on the other end into the sound card. Some external sound card or onboard sound card also corresponds to a different brand of CD-ROM drive, to provide two or more CD-In socket, when we have to drive brand corresponding socket insert applicable.
Tips: tips to prevent audio cable plugged into the wrong
Because the audio line is the most easy to insert the wrong, in order to avoid such a situation occurs. We can carefully observe the root audio cable, audio cable connectors will have an arrow mark (generally white cord to the position) will be marked with the CD-ROM drive and sound card audio line interface "L" phase The corresponding insertion can.